![]() Pressing Shift while dragging snaps the tool based on your snap settings. You can customize the snapping behavior in File>Options. Snap Constrain to objects, angular and linear increments, or grid points while you are sketching or editing solids. See Units options to change the minor grid spacing. The defaults are 1mm for Metric and 0.125in for Imperial units. The cursor will snap to the minor grid spacing increment while you sketch. to grid: Select this option turn snapping on or off while sketching. You can use the Snap to grid tool to constrain or lock all drawing to grid points only. If you don't have a point selected, it shows you the angle and distance from the origin. Polar dimensions show you an angle and a distance from the point you select. Polar dimensions: Select a point in a sketch and then click this option to see Polar dimensions from the point. If you don't have a point selected, it shows you the X and Y distances from the origin. Cartesian dimensions show you the X and Y distances from the point you select. The following options are available for every sketch tool:Ĭartesian dimensions: Select a point in a sketch and then click this option to see Cartesian dimensions from the point. When you drag a tangent arc, it increases its radius while maintaining its chord angle. The tangency indicator shows you how the new arc will be tangent with existing geometry if you click on the current cursor location.ĭrag the arc to edit it. This can be any point on an object in your design. ![]() You can switch between modes at any time. in the Mode Three ways of designing: Sketch, Cross-section, or 3D. If a sketch plane is active, click 3D Mode Three ways of designing: Sketch, Cross-section, or 3D.If a sketch plane is not active, press Esc.To draw a tangent arc between points in 3D The arc cannot end on its start point to make a circle or end on the same line as its start point. (Optional) Dimension the radius and chord angle. If two lines share an end point, use the scroll wheel to set tangency to the other line. This is usually done at the end point of a line, arc, or spline, but it can be on the line. The tool is disabled if there are no curves or lines in the sketch plane.Ĭlick the line or curve you want to draw tangent to. See Sweep arc, Three point arc, Tangent arc. Arc Curved line of constant radius part of a circle. You can sketch a line tangent to a curve or you can sketch an arc tangent to a line or curve. The sketch grid must be visible in the workspace before you can draw.Ĭlick Tangent Line that touches a curve (arc or circle) at only one point, without crossing over, and is perpendicular to the radius at the point of tangency. Line creates a surface and pulling a surface creates a solid. When converting a sketch to 3D, pulling a Use the Pull tool to offset, extrude, revolve, sweep,ĭraft, and blend faces or to round, chamfer, or extrude edges. This arc will become an edge when you pull your sketch into 3D with the Pull Tool used to distort or deform geometry. tool to sketch an arc that is tangent to a curve or line in your design. Use the Tangent Line that touches a curve (arc or circle) at only one point, without crossing over, and is perpendicular to the radius at the point of tangency. You are here: Designing > Sketching > Tangent arcs
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |